## Application of Empirical Gas Law Relationships?

Classify each situation by the equation that would quantify it.

A. A container of ammonia cleaner is stored in the janitor’s closet off a lecture hall after being used at night for cleaning. The container has a very small hole in the lid. The next morning the entire lecture hall smells of ammonia. How would you calculate the speed of the ammonia molecules as they move out into the lecture hall?

B. The pressure on a tire pump is read. The handle of the pump is pushed down as far as possible. The reading of the pressure on the gauge is taken again. How would you calculate the final pressure?

C. The burner under a hot air balloon is ignited and the balloon expands. How would you calculate the expanded volume of the balloon?

D. A front-end collision causes the air bag in an automobile to deploy by the reaction of sodium azide to produce nitrogen gas. How would you calculate how much sodium azide is needed to fill a standard size bag with nitrogen under STP conditions?

E. Aerosol cans have a label that warns the user not to use them above a certain temperature and not to dispose of them by incineration. Even an empty can contains residual gaseous propellant. If the residual pressure in the can is 1.31 atm when it is sitting on a shelf near a furnace, how could you calculate the pressure when the can is placed on top of the furnace where the temperature reaches the boiling point of water?

F. In an automobile engine, at the end of the upstroke the piston is at its maximum height in a cylinder of exact dimensions. At this time, a precisely measured mixture of fuel and oxidant ignites to form gaseous products. If the ignition temperature is known, how could you calculate the pressure inside the cylinder just before the piston moves downward?

Match with appropriate answers.

P1V1=P2V2

U=square root:(3RT/m)

(T1/V1)=(T2/V2)

PV=nRT

(P1/T1)=(P2/V2)

Uncategorized

Tags: aerosol cans, air bag, ammonia, automobile engine, boiling point of water, exact dimensions, gaseous products, hot air balloon, incineration, janitor, lecture hall, maximum height, nitrogen gas, propellant, residual pressure, sitting on a shelf, sodium azide, square root, tire pump, upstroke

This entry was posted
on Wednesday, January 5th, 2011 at 11:09 am and is filed under t1 speed.
You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.

im pretty sure

A,B are P1V1=P2V2

C is (T1/V1)=(T2/V2)

D is PV=nRT

E,F are (P1/T1)=(P2/V2)

im not sure about f

part b is 1.90 atm